[Offer to Sell] DH-2 Skid-detector |
||
|
||
No.1 Brief-introduction: DH-Ⅱ skid-detector is used to check and measure the skid between conveyor belt and active roller during the process of conveyor running. And avoid the destructive accidents due to skid. Furthermore, DH-Ⅱ skid-detector can be used to interlocked start and stop of multi-belt conveyors, and low-speed brake and speeding protection. No.2 Working Environment & Technical Parameters Altitude: less than 2000 meters; Ambient temperature: -35 degree~+60 degree; Relative humidity: less than 95%; Atmospheric pressure: 80~110 Kpa; Protective level: IP55; Contact capacity: ≤ AC380C 2A; Insulation resistance: ≥ 20 M Ω; Action direction: bidirectional way; Insulation voltage: AC500V, keep one minute; Reliability: 25,000 hours; Working location: please install on the direction-change roller and below the belt. It doesn’t work as the starting or stooping the belt conveyor machine. Output contact: one opening and one closed, one team converts the joint. No.3 Working Principle: As the DH-Ⅱ skid-detector working, the belt brings along the touchwheel(it is a wheel that must touch the belt as working), and read the actual belt speed through the running of touchwheel, which brings along the inner transmission shaft of the detector to work, and leads the inner velocity relay to work. As per the running of inner magnetism material, which produces magnetism that brings along the shifting fork to work and makes the joint produce the signals, such as opening or closed signal, and it is the detecting work of the machine. If there is different speed between belt and the active roller, and descends to 20-30% of the normal speed, the joint signals will change, at the same time, it will renewedly output new signal to control room, and alarm worker that the belt is in the serious state of skidding. |
||
|
||
Home | Privacy
Statement | Terms
of Use | Advertising | Partners | Contact
Us | Help
© Copyright 2001-2024, Trade-Database.com. All Rights Reserved.
|